Ultrasonic cleaning machine leakage causes and solutions
Browse Volume:978 Classify:Support
ultrasonic cleaning machine leakage reasons
Ultrasonic cleaning machine open the power switch, the indicator light does not light: this situation must be checked when repairing the power switch is intact, leakage switch is closed. If the switch is intact and then check whether the fuse is overloaded blown, basically can be solved. Ultrasonic cleaning machine DC fuse is blown. May be rectifier bridge stack or power tube burned, may also be the transducer aging, the current is not stable, these may cause power generator failure. Pay more attention when repairing.
Ultrasonic cleaning machine open the power switch, the light is on, but no ultrasonic output: this situation is more complex, repair first check the transducer and ultrasonic power board connection plug whether there is loose, and then check whether the fuse is blown. If everything is normal it is possible that the ultrasonic power generator internal fault, using a multimeter to play the power line bright line, the fire wire is all through. After excluding the generator fault then check whether the ultrasonic transducer is burnt out and whether it needs to be replaced.
Moisture: power supply part because the use of the environment humidity is too large. Caused by excessive leakage. Poor heat dissipation. Because the ultrasonic generator is a power device, it needs certain heat dissipation conditions. Poor heat dissipation causes the power supply to become hot, resulting in excessive leakage current. No reliable grounding. Many users, have a wrong understanding of grounding. This results in unreliable earthing of the electrical part. This results in leakage of electricity. The power supply is connected incorrectly. Small ultrasonic cleaning machine, ultrasonic cleaner. Is a single-phase power supply, but also to be clearly divided into L, N pole. Otherwise, there will also be leakage phenomenon.It could be used in sports equipment.
ultrasonic cleaning machine leakage how to do
Ensure that the connection:Operators in the use of ultrasonic cleaning machine, if the installation of ultrasonic heating device, must ensure that the ultrasonic heating device and ultrasonic power supply well connected together, if not effectively connected, not only may make the ultrasonic heating device heating, but also may have the phenomenon of power leakage.I suggest you have a look granboultrasonic cleaner
Working data: When opening the ultrasonic cleaning machine, the first thing to do is to adjust the voltage of the ultrasonic power supply to 220V and the frequency to about 50KHz, which is the common data when working with a single ultrasonic power supply. In the cleaning process, if you need to replace the new cleaning solution, you must first turn off the ultrasonic power switch before replacing it to avoid failure. After cleaning, the bottom of the ultrasonic cleaning tank to remove the sediment clean, to ensure that the ultrasonic cleaning machine again.
Well, now I believe that everyone should have a clear understanding of the causes of leakage of ultrasonic cleaning machine and response methods, the future of ultrasonic leakage problems do not have to worry about it. In fact, we usually use if you pay attention to a little leakage problem will be less likely to occur. So usually learn to learn more about the relevant just it, will certainly bring great convenience to our life.
Hello!